Manus Vacuum Pump
#1
Hi
Lads
This turned up today
Sadly it is seized
Starting to strip it down
It will make a good companion for my Lister
[Image: S1100061_zps155d4bf6.jpg]

[Image: S1100059_zps4b76e358.jpg]

[Image: S1100057_zps67f24cfb.jpg]

[Image: S1100058_zpsabd66565.jpg]

[Image: S1100060_zps93f329ca.jpg]

John
Reply
Thanks given by:
#2
What are you going to use it for John?

Ed
Reply
Thanks given by:
#3
(09-15-2014, 03:47 PM)EdK Wrote: What are you going to use it for John?

Ed

I will be showing the engine and pump at steam gatherings
I could use it to "suck" tin cans flat
It was used for milking cows JawdropJawdrop
John
Reply
Thanks given by: EdK
#4
It looks a fine beast John , I bet its nice and light to lift on your bench too is it Rotfl
Hope its nothing serious making it be seized.
Cheers Mick.
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#5
Looks like a fun project John. How about some pics of the Lister? I tried to find one over here a few years ago, but at the time they were pretty much non-existant in the states.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#6
nice john wont tack to mutch to free it off
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#7
Starting to look the part now
[Image: S1110011_zpseaa0587a.jpg]

[Image: S1110012_zpse0ac73c5.jpg]

[Image: S1110013_zps01534094.jpg]
Reply
Thanks given by:
#8
Looking good mate  Thumbsup


Did I leave my cup in your shop   Chin


Rob
Reply
Thanks given by:
#9
No
It was in the kitchen Mate
Can I borrow your hammer mould
Reply
Thanks given by:
#10
Aye nee bother mate , you going to do video ? Mick has loads of Lead .


Rob
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)