new machinist forum
#1
A new forum Machinist Talk has been launched.  It is not intended to replace any other forum, but to add to & supplement the knowledge base.  It can be found at http://forum.machinisttalk.com/
Reply
Thanks given by:
#2
I wish it luck, but it's looking a bit bleak at the moment with only one post ....


..... but everyone has to start somewhere !
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
#3
Looks like it's oriented toward professional machinists.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:
#4
(04-27-2016, 05:04 PM)chucketn Wrote: Looks like it's oriented toward professional machinists.

Chuck

If it is, I'd be in over my head. I like it better here!
Reply
Thanks given by:
#5
mee too!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
#6
Well give it some time as it just began. BTW, not limited to professionals.
Reply
Thanks given by:
#7
Sounds like posting something made out of wood will get you banned.  Big Grin
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#8
Not sure that I can stand the pace on that new forum ....

... 24 hours elapsed and STILL only one post.

Go on Tom, post a nice wood theme :)
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
#9
when opening this thread, only 2 posts appeared until I replied, then the rest were visible. weird, never seen that before.

Chuck
Reply
Thanks given by:
#10
Interesting - the admin has 12 posts and a bucket load of reputation points. I only saw one post but clicking on all activity (top right) suggested there is more.

Perhaps he is wary of people taking his posts and placing them verbatim on their own site...
Hunting American dentists since 2015.
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)