Kondia FV-1 Head disassembly
That would make a lot of sense Ken. Laying flat you could feel the fit, would't be fighting the weight of the knee.
Come to think of it that sounds like fun I really think you should strip it all down and give it a go, just for chuckles.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: PixMan
Here are the little buggers and the section of the drawing that should have alerted me to the fact that these needed to go in before the knee was put back on.

   
   

Knee in position on the hoist (no need to remove fully).

   

One of the holes

   

Back to where I started.

   

All sorted in 16 minutes and 24 seconds Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
And so how are you adjusting the gib for smooth sliding action without being too loose?

I suppose you can feel the tension pretty good.
Reply
Thanks given by:
With the hoist in place and tension on the sling, I removed the gib completely. Once finished I lowered the knee back down until the pedestal was just about in contact with the base. I then put the four bolts in finger tight, let the knee all the way down and then put the gib back in. Whilst the pedestal is in contact with the base, I kept some tension on the sling whilst putting the gib in. Finally I removed the sling, and cranked the knee up and down a few times I tightened the bolts on the pedestal. It moves very nicely.
Hunting American dentists since 2015.
Reply
Thanks given by:
very good job!
Reply
Thanks given by: Mayhem
Smiley-signs009

Ed
Reply
Thanks given by: Mayhem
Darren, That's a lot of work done in "16 minutes and 24 seconds", Good job, well done. Thumbsup

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by: Mayhem
Thanks Steve - after responding to Ken by saying that whilst he was planning an alternative I would have finished, I thought I had better get the stop watch out to see if I needed to edit my post Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
So now what is left to do before you can make square features and perpendicular holes?
Reply
Thanks given by:
(03-21-2015, 08:15 AM)PixMan Wrote: So now what is left to do before you can make square features and perpendicular holes?

To start with, I need some 8mm roll pins.  I've not seen any in fewer than 500 bulk.  Today I thought I was on a winner when I saw a 120 piece assorted metric roll pin box, which listed 8 x 40mm and 8 x 50mm.  I got the box home and found that the 8mm ones are actually ø7.75 Bash

Without these, I cannot locate the yoke and sort out the misaligned bolt holes...
Hunting American dentists since 2015.
Reply
Thanks given by:




Users browsing this thread: 10 Guest(s)