|
Tuning Up a HF Tool Bit Grinder
|
09-06-2012, 06:22 PM
Ed, it looks a lot like the Baldor I have. I go along with the white wheel on the left but if you're using the the green one on the right for carbide it just doesn't cut it (so to speak). You have, of course read Harold-V's discourses. Can we argue against him?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tuning Up a HF Tool Bit Grinder - by EdK - 09-06-2012, 06:05 PM
RE: Tuning Up a HF Tool Bit Grinder - by TOM REED - 09-06-2012, 06:22 PM
RE: Tuning Up a HF Tool Bit Grinder - by stevec - 09-06-2012, 06:22 PM
RE: Tuning Up a HF Tool Bit Grinder - by EdK - 09-06-2012, 06:40 PM
RE: Tuning Up a HF Tool Bit Grinder - by Mayhem - 09-06-2012, 07:36 PM
RE: Tuning Up a HF Tool Bit Grinder - by Highpower - 09-06-2012, 08:38 PM
RE: Tuning Up a HF Tool Bit Grinder - by EdK - 09-07-2012, 05:44 AM
RE: Tuning Up a HF Tool Bit Grinder - by Highpower - 09-07-2012, 09:05 AM
RE: Tuning Up a HF Tool Bit Grinder - by doubleboost - 09-07-2012, 05:44 AM
RE: Tuning Up a HF Tool Bit Grinder - by EdK - 09-07-2012, 05:47 AM
|
