Drill Press Vise Modification
#12
Jack,

When or if you have to bore out a grinding wheel I strongly suggest you put some thick paper (similar to the center blotter) under the wheel and under those clamps. If you don't you risk cracking the wheel. I hope you give that grinding wheel a ring test before mounting it on the grinder, then let it run for at least one minute at full speed before using it.
Reply
Thanks given by:


Messages In This Thread
Drill Press Vise Modification - by the penguin - 11-21-2012, 10:13 AM
RE: Drill Press Vise Modification - by EdK - 11-21-2012, 11:08 AM
RE: Drill Press Vise Modification - by Micktoon - 11-21-2012, 03:42 PM
RE: Drill Press Vise Modification - by DaveH - 11-21-2012, 05:33 PM
RE: Drill Press Vise Modification - by Arbalest - 11-24-2012, 02:39 PM
RE: Drill Press Vise Modification - by stevec - 11-24-2012, 03:39 PM
RE: Drill Press Vise Modification - by Arbalest - 11-25-2012, 04:26 PM
RE: Drill Press Vise Modification - by ETC57 - 11-24-2012, 04:25 PM
RE: Drill Press Vise Modification - by krv3000 - 11-24-2012, 06:00 PM
RE: Drill Press Vise Modification - by pamrick - 11-25-2012, 09:35 AM
RE: Drill Press Vise Modification - by PixMan - 11-25-2012, 11:20 AM
RE: Drill Press Vise Modification - by EdK - 11-25-2012, 02:44 PM
RE: Drill Press Vise Modification - by sasquatch - 11-25-2012, 04:27 PM
RE: Drill Press Vise Modification - by pamrick - 11-26-2012, 09:26 PM
RE: Drill Press Vise Modification - by sasquatch - 11-26-2012, 09:46 PM



Users browsing this thread: 1 Guest(s)