D.T.I stand refit

[krv3000]

hi all well i had a full day in the workshop today and i had a project i have had the stand for sum time the magnet in it was OK so it was worth fixing up first job get the magnet out to my surprise it just came strate out the next job was to clean it up i removed as much of the old pant by hand then set it up in the 4 jaw chuck to clean the sides off then i had to mack up a front cover plate i made this out of a peace of aluminum plate 4mm thick i drilled the center out then with me boring bar bored out the hole to 32mm then i had to put a step in 2mm deep by 38mm wide this is for the device that will rotate the magnet right pics