me grindre refit
#10
SNAP!

I've got the same grinder, except I repainted mine in hammered gold. Do you have the end covers Bob, there are some, the really early ones that didn't have end plates, apparently if it's got little 1/8"th holes in the edge of the cast wheel guards it should have the end plates, mine were there but rough, they took a couple of hours with a hammer and dolly to get right, now you couldn't tell they were ever bent.

Mine came as a lump of dust and muck in a pile of old cracked flat drive leather belts and other dross, the guys that used to work for me thought I was nuts bothering with it;

First they said "it'll never run",
Then they said "it's not worth cleaning",
Next it was "it's just too old",
then"Why paint it"

Now they say "Can I borrow it"

Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:


Messages In This Thread
me grindre refit - by krv3000 - 08-20-2013, 05:19 PM
RE: me grindre refit - by doubleboost - 08-20-2013, 05:28 PM
RE: me grindre refit - by krv3000 - 08-20-2013, 05:35 PM
RE: me grindre refit - by Mayhem - 08-20-2013, 06:02 PM
RE: me grindre refit - by EdK - 08-20-2013, 06:47 PM
RE: me grindre refit - by Micktoon - 08-21-2013, 05:24 PM
RE: me grindre refit - by krv3000 - 08-22-2013, 05:49 PM
RE: me grindre refit - by sasquatch - 08-22-2013, 07:23 PM
RE: me grindre refit - by krv3000 - 08-31-2013, 05:58 PM
RE: me grindre refit - by Rickabilly - 09-01-2013, 03:15 PM
RE: me grindre refit - by Rickabilly - 09-01-2013, 03:18 PM
RE: me grindre refit - by Micktoon - 09-01-2013, 03:41 PM
RE: me grindre refit - by krv3000 - 09-01-2013, 04:06 PM
RE: me grindre refit - by Rickabilly - 09-01-2013, 04:21 PM
RE: me grindre refit - by krv3000 - 09-01-2013, 04:59 PM
RE: me grindre refit - by Rickabilly - 09-01-2013, 05:45 PM
RE: me grindre refit - by krv3000 - 09-01-2013, 05:48 PM
RE: me grindre refit - by DaveH - 09-02-2013, 06:15 AM



Users browsing this thread: 1 Guest(s)