My attempt at a QCTP Tangential tool

[chucketn]

(08-22-2013, 05:24 PM)f350ca Wrote: Nice tool Chuck, does the locking screw clear when your facing? Mine doesn't, have seen a few designs with wedges that put the screw or nut on the other side out of the way.

Thanks Greg, this is probably the most complicated thing I have milled to date. I really had to stand on my head and hold my mouth just right! LOL, just kidding, but it certainly was a challenge. I've only tried it on small diameter stuff so far, but today I found a piece of unknownium steel that has proof of nasty finish from my normal HSS tooling. It's about 1 1/2"-2" in dia. I will try a cleanup cut on it tomorrow with before and after pic's.
Chuck