this isn't a how to but more of a how do I

[dallen]

(04-03-2014, 12:16 PM)stevec Wrote: DA, I'm not sure I know what "collored bushings" are but I wouldn't try to turn down "hardened linear rails" nor "thread them".
Could you not just grind a flat for setscrews in the tapped holes in the brackets?

bushing with a flanged on one end,

Problem with set screws is that the plates are only a half inch thick , and theres no reason that they can't be turned when the ball screws are just as hard and one of them I'm going to have to shorten and turn a place for a bearing on the end of it.