04-10-2014, 05:41 PM
I can see the disc surface being dead true but what about the surface that would site on the mill table? Sorry, I'm not that familiar with rotors.
Thanks,
Ed
Thanks,
Ed
|
Traming plate?????
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Traming plate????? - by Brian - 04-07-2014, 02:28 PM
RE: Traming plate????? - by JScott - 04-07-2014, 04:21 PM
RE: Traming plate????? - by PixMan - 04-10-2014, 09:20 AM
RE: Traming plate????? - by JScott - 04-10-2014, 10:33 AM
RE: Traming plate????? - by doubleboost - 04-10-2014, 04:13 PM
RE: Traming plate????? - by EdK - 04-10-2014, 04:48 PM
RE: Traming plate????? - by doubleboost - 04-10-2014, 04:54 PM
RE: Traming plate????? - by dallen - 04-10-2014, 05:22 PM
RE: Traming plate????? - by EdK - 04-10-2014, 05:41 PM
RE: Traming plate????? - by doubleboost - 04-10-2014, 05:47 PM
RE: Traming plate????? - by the penguin - 04-10-2014, 07:30 PM
RE: Traming plate????? - by roundrocktom - 04-11-2014, 11:37 AM
RE: Traming plate????? - by roundrocktom - 04-12-2014, 03:18 PM
RE: Traming plate????? - by doubleboost - 04-12-2014, 04:09 PM
RE: Traming plate????? - by EdK - 04-12-2014, 05:45 PM
RE: Traming plate????? - by roundrocktom - 04-12-2014, 07:00 PM
RE: Traming plate????? - by doubleboost - 04-13-2014, 03:16 AM
RE: Traming plate????? - by Mayhem - 04-13-2014, 03:38 AM
RE: Traming plate????? - by the penguin - 04-13-2014, 07:12 AM
RE: Traming plate????? - by Brian - 05-04-2014, 02:20 PM
RE: Traming plate????? - by ETC57 - 06-08-2014, 11:32 AM
|
Users browsing this thread: 1 Guest(s)