Traming plate?????
#12
(04-10-2014, 07:30 PM)the penguin Wrote: I use a disc brake rotor, it in any doubt about the trueness, rotate the disc 90 degrees and recheck, my reading were identical.

Yes, but will my 0.000 1 indicator run true on it. :) Smiley-dancenana
roundrocktom, proud to be a member of MetalworkingFun Forum since Mar 2014.
Reply
Thanks given by:


Messages In This Thread
Traming plate????? - by Brian - 04-07-2014, 02:28 PM
RE: Traming plate????? - by JScott - 04-07-2014, 04:21 PM
RE: Traming plate????? - by PixMan - 04-10-2014, 09:20 AM
RE: Traming plate????? - by JScott - 04-10-2014, 10:33 AM
RE: Traming plate????? - by doubleboost - 04-10-2014, 04:13 PM
RE: Traming plate????? - by EdK - 04-10-2014, 04:48 PM
RE: Traming plate????? - by doubleboost - 04-10-2014, 04:54 PM
RE: Traming plate????? - by dallen - 04-10-2014, 05:22 PM
RE: Traming plate????? - by EdK - 04-10-2014, 05:41 PM
RE: Traming plate????? - by doubleboost - 04-10-2014, 05:47 PM
RE: Traming plate????? - by the penguin - 04-10-2014, 07:30 PM
RE: Traming plate????? - by roundrocktom - 04-11-2014, 11:37 AM
RE: Traming plate????? - by roundrocktom - 04-12-2014, 03:18 PM
RE: Traming plate????? - by doubleboost - 04-12-2014, 04:09 PM
RE: Traming plate????? - by EdK - 04-12-2014, 05:45 PM
RE: Traming plate????? - by roundrocktom - 04-12-2014, 07:00 PM
RE: Traming plate????? - by doubleboost - 04-13-2014, 03:16 AM
RE: Traming plate????? - by Mayhem - 04-13-2014, 03:38 AM
RE: Traming plate????? - by the penguin - 04-13-2014, 07:12 AM
RE: Traming plate????? - by Brian - 05-04-2014, 02:20 PM
RE: Traming plate????? - by ETC57 - 06-08-2014, 11:32 AM



Users browsing this thread: 1 Guest(s)