The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




Making a steel lathe chuck plate.
#1
Here is the start of the lathe chuck plate i am making. I always was told use cast iron then i bought a few chucks that had steel plates and they work just fine. Then i bought a whole bunch more chucks and they needed back plates so steel is the easiest and cheapest for me. I used my trusty Miller 185 and solid .030 wire with 75/25 gas. Just my thoughts...Bob


Attached Files Thumbnail(s)
                   
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 11:50 AM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 02:17 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 04:03 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 04:24 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 05:28 PM



Users browsing this thread: 1 Guest(s)