|
tale of two indicator holders
|
09-09-2012, 11:40 AM
The only problem I see with an indicator placed in the tool holder is that you have to remove the knife, place indicator, put back the knife, loose accuracy...I like to have the indicator chase the knife as I cut to check for run-off and parallel plane.
Kaoma, proud to be a member of MetalworkingFun Forum since Apr 2012.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
tale of two indicator holders - by dallen - 04-20-2012, 08:35 AM
RE: tale of two indicator holders - by miner49r - 04-20-2012, 10:05 AM
RE: tale of two indicator holders - by EdK - 04-20-2012, 11:02 AM
RE: tale of two indicator holders - by DaveH - 04-20-2012, 01:53 PM
RE: tale of two indicator holders - by doubleboost - 04-20-2012, 03:38 PM
RE: tale of two indicator holders - by krv3000 - 04-20-2012, 05:23 PM
RE: tale of two indicator holders - by PixMan - 05-13-2012, 09:21 AM
RE: tale of two indicator holders - by flutedchamber - 09-08-2012, 10:33 PM
RE: tale of two indicator holders - by dallen - 09-09-2012, 08:39 AM
RE: tale of two indicator holders - by Wawoodman - 09-09-2012, 09:31 AM
RE: tale of two indicator holders - by dallen - 09-09-2012, 10:32 AM
RE: tale of two indicator holders - by Wawoodman - 09-09-2012, 11:27 AM
RE: tale of two indicator holders - by Kaoma - 09-09-2012, 11:40 AM
RE: tale of two indicator holders - by dallen - 09-09-2012, 01:24 PM
|
