MetalworkingFun Forum › Machining › How-To's v
Tom G, it's 2017 how about a video?

Thread Modes
Tom G, it's 2017 how about a video?
Dr Stan Offline
Senior
*****
Posts: 2,324
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#6
01-09-2017, 05:45 PM
(01-08-2017, 07:53 PM)Vinny Wrote: You've obviously never seen the gear making video by Jose something.  All throughout he's using the wrong value for PI and counting the wrong number of turns on the rotary table.

Got the web address?
Reply
Thanks given by:


Messages In This Thread
RE: Tom G, it's 2017 how about a video? - by EdK - 01-07-2017, 10:27 PM
RE: Tom G, it's 2017 how about a video? - by Dr Stan - 01-09-2017, 05:45 PM
RE: Tom G, it's 2017 how about a video? - by EdK - 01-09-2017, 06:42 PM
RE: Tom G, it's 2017 how about a video? - by TomG - 01-10-2017, 08:47 PM
RE: Tom G, it's 2017 how about a video? - by EdK - 01-10-2017, 09:03 PM
RE: Tom G, it's 2017 how about a video? - by EdK - 03-03-2017, 05:44 PM
RE: Tom G, it's 2017 how about a video? - by pepi - 03-04-2017, 06:45 AM



Users browsing this thread: 1 Guest(s)