Self setting parallels for the drilling vice

Hello There, Guest! Register

Thread Modes

Self setting parallels for the drilling vice

TomG Offline

Offline

Alt. Whipping Boy

Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan

#9

01-23-2017, 05:38 PM

I normally use a compression spring when needed, but this is more elegant. Big Grin

Big Grin

Thanks for posting the design.

Tom

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Self setting parallels for the drilling vice - by homemetalman - 01-23-2017, 09:06 AM

RE: Self setting parallels for the drilling vice - by f350ca - 01-23-2017, 10:27 AM

RE: Self setting parallels for the drilling vice - by Mayhem - 01-23-2017, 11:37 AM

RE: Self setting parallels for the drilling vice - by awemawson - 01-23-2017, 12:37 PM

RE: Self setting parallels for the drilling vice - by f350ca - 01-23-2017, 01:53 PM

RE: Self setting parallels for the drilling vice - by homemetalman - 01-23-2017, 03:46 PM

RE: Self setting parallels for the drilling vice - by awemawson - 01-23-2017, 04:20 PM

RE: Self setting parallels for the drilling vice - by EdK - 01-23-2017, 05:19 PM

RE: Self setting parallels for the drilling vice - by TomG - 01-23-2017, 05:38 PM

Users browsing this thread: 1 Guest(s)