|
New Forum!!!
|
06-27-2020, 10:10 PM
(06-27-2020, 05:33 PM)EdK Wrote: Any suggestions for a source of reasonably priced filament of good quality? I've found Microcenter's Inland brand PLA to be a very good value. They have lots stock and colors on hand and at $19 a 1kg spool it's hard to beat. There may be better quality filaments out there but for what I print it does job. I'm in the process of building an enclosure so I can give their ABS a try. Thanks given by: EdK
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
New Forum!!! - by Vinny - 07-04-2017, 10:00 AM
RE: New Forum!!! - by Hawkeye - 07-04-2017, 10:33 PM
RE: New Forum!!! - by chucketn - 07-06-2017, 07:45 AM
RE: New Forum!!! - by Vinny - 07-06-2017, 08:20 AM
RE: New Forum!!! - by Hawkeye - 07-07-2017, 11:04 PM
RE: New Forum!!! - by Vinny - 07-08-2017, 10:23 AM
RE: New Forum!!! - by Hawkeye - 07-08-2017, 11:15 PM
RE: New Forum!!! - by EdK - 06-27-2020, 05:33 PM
RE: New Forum!!! - by arvidj - 06-27-2020, 10:10 PM
RE: New Forum!!! - by EdK - 06-27-2020, 11:11 PM
RE: New Forum!!! - by Vinny - 06-28-2020, 01:34 AM
RE: New Forum!!! - by arvidj - 06-28-2020, 07:28 AM
RE: New Forum!!! - by Vinny - 06-27-2020, 08:16 PM
|
