Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe
#6
Nice work Dave,

You mentioned the bore, you mean the chuck bore right? allowing you to throat larger stock.

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by ETC57 - 05-09-2012, 09:35 AM



Users browsing this thread: 2 Guest(s)