Fly cutter project!!!

[pjf134]

I decided to make a fly cutter for the mill, so I put a piece of 3/4" dia. cold rolled in the lathe and turned down the shaft to fit the mill holder. Next I set up the rotary table on the mill and cut the tool slot the 10 degrees needed and added a set screw to hold the tool in place and grind the tool for the fly cutter then tried it out. I was going to stone the cutter, but I think it is good the way it is after I leveled a piece of aluminum angle. The flash on the camera made the pic a little shinny, then my battery went in the camera, so what you see is what you get for now.
Paul