new tabel
#7
well you will need a bucket a bar of sope a oil stone that ant had any oil on it and wet and dry sand paper soke the oil stone in the bucket give it a rub with the sope then just start rubbing start with the cores grit then the fine then finish of with 400 wet and dry sand paper used wet with the sope you will get a nice finish did not do the top just the edges rounded them off ps don't put was up deturgent in the bucket as this will a fekd the wet and dry sand paper ie the grit cums off
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
new tabel - by krv3000 - 06-10-2012, 04:21 PM
RE: new tabel - by doubleboost - 06-10-2012, 04:27 PM
RE: new tabel - by DaveH - 06-10-2012, 04:56 PM
RE: new tabel - by Rickabilly - 06-11-2012, 08:09 AM
RE: new tabel - by krv3000 - 06-11-2012, 08:23 AM
RE: new tabel - by Rickabilly - 06-11-2012, 08:25 AM
RE: new tabel - by krv3000 - 06-11-2012, 08:44 AM
RE: new tabel - by Rickabilly - 06-11-2012, 08:50 AM
RE: new tabel - by krv3000 - 06-11-2012, 09:10 AM
RE: new tabel - by EdK - 06-11-2012, 04:22 PM
RE: new tabel - by ETC57 - 06-11-2012, 09:31 AM



Users browsing this thread: 2 Guest(s)