06-25-2015, 08:09 AM
(06-24-2015, 09:22 PM)TomG Wrote: Had some time top make chips this evening so I whittled away at my AR-15 forgings a bit. The task at hand was to bore and thread the 1 3/16-16 hole for the buffer tube, the anti rotation hole and the hole for the take down pin detent. The thread was fun because it required a fixture to hold the receiver in the lathe so I could single point the thread (I'm too cheap to buy a tap). I'm going to try to finish them before heading North over the fourth. One can never make too much noise on the fourth of July.
Tom
Looks great Tom. Are we to expect seeing a new video on this soon? I love watching your videos.
Mike.