Moulding Flasks ,,, Steel
#18
Of course temperature is relative when it comes to impact loading and impact loading too is greatly reduced as the concrete jacket greatly dampens most impacts, that might be relevant.

My point was that the composite construction of steel plus concrete is of greater importance than the actual properties of either the steel or the concrete used in any single case. but often folks think that the steel must be special to achieve what the composite construction does.

Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:


Messages In This Thread
Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 05:03 AM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 05:05 AM
RE: Moulding Flasks ,,, Steel - by Mayhem - 02-26-2012, 06:58 AM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 07:01 AM
RE: Moulding Flasks ,,, Steel - by Mayhem - 02-26-2012, 07:16 AM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 07:21 AM
RE: Moulding Flasks ,,, Steel - by DaveH - 02-26-2012, 07:39 AM
RE: Moulding Flasks ,,, Steel - by ETC57 - 02-26-2012, 12:27 PM
RE: Moulding Flasks ,,, Steel - by EdK - 02-26-2012, 12:59 PM
RE: Moulding Flasks ,,, Steel - by TOM REED - 02-26-2012, 03:59 PM
RE: Moulding Flasks ,,, Steel - by RobWilson - 02-26-2012, 04:44 PM
RE: Moulding Flasks ,,, Steel - by EdK - 03-02-2012, 08:00 PM
RE: Moulding Flasks ,,, Steel - by stevec - 09-16-2012, 06:45 AM
RE: Moulding Flasks ,,, Steel - by Rickabilly - 09-16-2012, 06:18 AM
RE: Moulding Flasks ,,, Steel - by Rickabilly - 09-16-2012, 06:21 AM
RE: Moulding Flasks ,,, Steel - by Mayhem - 09-16-2012, 07:42 AM
RE: Moulding Flasks ,,, Steel - by stevec - 09-16-2012, 11:31 AM
RE: Moulding Flasks ,,, Steel - by Rickabilly - 09-16-2012, 04:12 PM



Users browsing this thread: 1 Guest(s)