02-25-2014, 12:20 PM
it would be great if I could get some that shows the table feed with maybe a ruler in this for scale, I'm still working on the shaper (actually fired it up Saturday for a few minutes), I have to pull the big gear out of it as there's something in it that makes a knocking sound that shouldn't be there.
I had a guy in Fairbanks Alaska that sent me some photo's but his shaper has a different leadscrew in it then mine has.
Damn shame about you being in Ohio, too far to drive over and take an up close look at it.
YES Photo's please, good clear ones that show everything and the hand wheel on top I need to make one of those also.
DA
I had a guy in Fairbanks Alaska that sent me some photo's but his shaper has a different leadscrew in it then mine has.
Damn shame about you being in Ohio, too far to drive over and take an up close look at it.
YES Photo's please, good clear ones that show everything and the hand wheel on top I need to make one of those also.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!