crank handle for Cincinnati 16" shaper

Hello There, Guest! Register

Thread Modes

crank handle for Cincinnati 16" shaper

dallen Offline

Offline

Senior

Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma

The following 3 users Like dallen's post:
EdK (09-17-2013), mattinker (09-18-2013), the artfull-codger (11-13-2013)

#5

09-17-2013, 05:33 PM

guess I can put the handcrank to bed now I was able to cast one in Cast Iron today.

DA

dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue

Tongue

Reply

« Next Oldest | Next Newest »

Messages In This Thread

crank handle for Cincinnati 16" shaper - by dallen - 09-05-2013, 10:51 AM

RE: crank handle for Cincinnati 16" shaper - by dallen - 09-09-2013, 09:23 PM

RE: crank handle for Cincinnati 16" shaper - by dallen - 09-12-2013, 12:34 PM

RE: crank handle for Cincinnati 16" shaper - by dallen - 09-16-2013, 08:13 PM

RE: crank handle for Cincinnati 16" shaper - by dallen - 09-17-2013, 05:33 PM

RE: crank handle for Cincinnati 16" shaper - by LJP - 09-17-2013, 08:18 PM

RE: crank handle for Cincinnati 16" shaper - by dallen - 11-21-2013, 04:52 PM

RE: crank handle for Cincinnati 16" shaper - by awemawson - 11-21-2013, 05:06 PM

RE: crank handle for Cincinnati 16" shaper - by dallen - 11-21-2013, 05:46 PM

RE: crank handle for Cincinnati 16" shaper - by dallen - 11-22-2013, 11:17 AM

RE: crank handle for Cincinnati 16" shaper - by awemawson - 11-22-2013, 11:56 AM

RE: crank handle for Cincinnati 16" shaper - by dallen - 11-22-2013, 01:46 PM

RE: crank handle for Cincinnati 16" shaper - by doubleboost - 11-22-2013, 03:50 PM

RE: crank handle for Cincinnati 16" shaper - by dallen - 11-22-2013, 05:25 PM

RE: crank handle for Cincinnati 16" shaper - by DaveH - 11-24-2013, 02:03 PM

Users browsing this thread: 2 Guest(s)