Need a project
#26
When I get a new employee , I do the same thing that was done to me , which is this : I hand them a piece of aluminum and instructions to make it square , it's not as easy as it sounds , but it will teach you things about your machine .
kenne, proud to be a member of MetalworkingFun Forum since Jun 2014.
Reply
Thanks given by:


Messages In This Thread
Need a project - by ironman - 04-29-2014, 03:09 PM
RE: Need a project - by DaveH - 04-29-2014, 04:13 PM
RE: Need a project - by DaveH - 04-29-2014, 04:21 PM
RE: Need a project - by DaveH - 04-29-2014, 04:30 PM
RE: Need a project - by doubleboost - 04-29-2014, 04:52 PM
RE: Need a project - by TomG - 04-29-2014, 05:13 PM
RE: Need a project - by DaveH - 04-29-2014, 05:38 PM
RE: Need a project - by TomG - 04-29-2014, 06:12 PM
RE: Need a project - by EdK - 04-30-2014, 05:09 AM
RE: Need a project - by Sunset Machine - 04-29-2014, 10:34 PM
RE: Need a project - by ironman - 04-30-2014, 12:12 AM
RE: Need a project - by ironman - 04-30-2014, 02:58 PM
RE: Need a project - by ironman - 04-30-2014, 03:02 PM
RE: Need a project - by DaveH - 05-01-2014, 08:26 AM
RE: Need a project - by DaveH - 05-01-2014, 08:30 AM
RE: Need a project - by ironman - 05-02-2014, 02:48 AM
RE: Need a project - by Mayhem - 05-01-2014, 08:07 PM
RE: Need a project - by ironman - 05-02-2014, 02:50 AM
RE: Need a project - by ironman - 05-02-2014, 02:54 AM
RE: Need a project - by EdK - 05-02-2014, 05:29 AM
RE: Need a project - by stevec - 05-02-2014, 05:57 AM
RE: Need a project - by Mayhem - 05-02-2014, 08:12 PM
RE: Need a project - by PixMan - 05-02-2014, 08:23 PM
RE: Need a project - by ironman - 05-03-2014, 02:10 AM
RE: Need a project - by ironman - 05-06-2014, 06:39 AM
RE: Need a project - by kenne - 06-12-2014, 09:55 PM
RE: Need a project - by ironman - 06-13-2014, 03:48 AM



Users browsing this thread: 1 Guest(s)