Round HSS inserts
#5
(10-25-2014, 06:45 PM)dallen Wrote: what diameter are you looking for

If I read the spec correctly, the inserts are 10mm with 4mm hole for the screw.

Insert here: http://www.ctctools.biz/servlet/the-721/...ING/Detail

tool holder here: http://www.ctctools.biz/servlet/the-611/...the/Detail

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Round HSS inserts - by chucketn - 10-25-2014, 04:00 PM
RE: Round HSS inserts - by Dr Stan - 10-25-2014, 05:04 PM
RE: Round HSS inserts - by chucketn - 10-25-2014, 06:03 PM
RE: Round HSS inserts - by dallen - 10-25-2014, 06:45 PM
RE: Round HSS inserts - by chucketn - 10-25-2014, 07:28 PM
RE: Round HSS inserts - by dallen - 10-25-2014, 08:32 PM
RE: Round HSS inserts - by chucketn - 10-26-2014, 05:59 AM
RE: Round HSS inserts - by dallen - 10-26-2014, 08:15 AM
RE: Round HSS inserts - by chipist - 10-26-2014, 01:00 PM
RE: Round HSS inserts - by Dr Stan - 10-26-2014, 10:25 PM
RE: Round HSS inserts - by PixMan - 10-27-2014, 06:31 AM



Users browsing this thread: 1 Guest(s)