MetalworkingFun Forum › Machining › Projects v
tale of two indicator holders

Thread Modes
tale of two indicator holders
Wawoodman
Unregistered
 
#10
09-09-2012, 09:31 AM
And the use of that is for more accuracy than the bump wheel method?

When making that, how is the center portion excavated? Was that done with a boring bar? Is the interrupted cut an issue?

Lord, I've got a lot to learn! Bash
Reply
Thanks given by:


Messages In This Thread
tale of two indicator holders - by dallen - 04-20-2012, 08:35 AM
RE: tale of two indicator holders - by miner49r - 04-20-2012, 10:05 AM
RE: tale of two indicator holders - by EdK - 04-20-2012, 11:02 AM
RE: tale of two indicator holders - by DaveH - 04-20-2012, 01:53 PM
RE: tale of two indicator holders - by krv3000 - 04-20-2012, 05:23 PM
RE: tale of two indicator holders - by PixMan - 05-13-2012, 09:21 AM
RE: tale of two indicator holders - by flutedchamber - 09-08-2012, 10:33 PM
RE: tale of two indicator holders - by dallen - 09-09-2012, 08:39 AM
RE: tale of two indicator holders - by Wawoodman - 09-09-2012, 09:31 AM
RE: tale of two indicator holders - by dallen - 09-09-2012, 10:32 AM
RE: tale of two indicator holders - by Wawoodman - 09-09-2012, 11:27 AM
RE: tale of two indicator holders - by Kaoma - 09-09-2012, 11:40 AM
RE: tale of two indicator holders - by dallen - 09-09-2012, 01:24 PM



Users browsing this thread: 1 Guest(s)