MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Vise Sizing

Thread Modes
Vise Sizing
EdK Offline
Whipping Boy
*******
Posts: 8,746
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#6
05-05-2017, 08:18 PM
(05-05-2017, 07:45 PM)Mayhem Wrote:
(05-05-2017, 07:12 PM)EdK Wrote: ...Actually, I got no detectable run-out...

You did make sure the indicator tip was touching the jaw, didn't you?  Big Grin

Yes. I couldn't believe it at first but ran the test a number of times.

Ed
Reply
Thanks given by:


Messages In This Thread
Vise Sizing - by the penguin - 05-05-2017, 12:22 PM
RE: Vise Sizing - by wawoodman - 05-05-2017, 01:06 PM
RE: Vise Sizing - by Vinny - 05-05-2017, 01:20 PM
RE: Vise Sizing - by EdK - 05-05-2017, 07:12 PM
RE: Vise Sizing - by Mayhem - 05-05-2017, 07:45 PM
RE: Vise Sizing - by EdK - 05-05-2017, 08:18 PM
RE: Vise Sizing - by Mike E. - 05-06-2017, 06:27 AM
RE: Vise Sizing - by Mayhem - 05-06-2017, 10:47 AM
RE: Vise Sizing - by EdK - 05-06-2017, 11:13 AM
RE: Vise Sizing - by Mike E. - 05-06-2017, 10:57 AM
RE: Vise Sizing - by Dr Stan - 05-06-2017, 12:36 PM



Users browsing this thread: 1 Guest(s)