05-06-2017, 06:27 AM
The most suitable vise I have for my mill's 6" x 32" table is a 4 1/2" Jones and Shipman model. Here are a couple of photos, with one alongside my 6" vise for comparison.
Mike
|
Vise Sizing
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Vise Sizing - by the penguin - 05-05-2017, 12:22 PM
RE: Vise Sizing - by wawoodman - 05-05-2017, 01:06 PM
RE: Vise Sizing - by Vinny - 05-05-2017, 01:20 PM
RE: Vise Sizing - by EdK - 05-05-2017, 07:12 PM
RE: Vise Sizing - by Mayhem - 05-05-2017, 07:45 PM
RE: Vise Sizing - by EdK - 05-05-2017, 08:18 PM
RE: Vise Sizing - by Mike E. - 05-06-2017, 06:27 AM
RE: Vise Sizing - by Mayhem - 05-06-2017, 10:47 AM
RE: Vise Sizing - by EdK - 05-06-2017, 11:13 AM
RE: Vise Sizing - by Mike E. - 05-06-2017, 10:57 AM
RE: Vise Sizing - by Dr Stan - 05-06-2017, 12:36 PM
|
Users browsing this thread: 1 Guest(s)