MetalworkingFun Forum › Machining › 3D Printing v
New Forum!!!

Thread Modes
New Forum!!!
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#3
07-06-2017, 07:45 AM
Thanks for adding this forum. I have a Anet A8 and am enjoying it. Except, I fubared the main board by disconnecting the extruder stepper while under power to troubleshoot a jam. Blew the onboard driver chip. Tried a Ramps 1.4 kit and for some reason it craped one of its stepper driver. Ordered an oem main board to get it going again while I figure out the Ramps problems.
Also got a 3d scanner in the works...

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
New Forum!!! - by Vinny - 07-04-2017, 10:00 AM
RE: New Forum!!! - by Hawkeye - 07-04-2017, 10:33 PM
RE: New Forum!!! - by chucketn - 07-06-2017, 07:45 AM
RE: New Forum!!! - by Vinny - 07-06-2017, 08:20 AM
RE: New Forum!!! - by Hawkeye - 07-07-2017, 11:04 PM
RE: New Forum!!! - by Vinny - 07-08-2017, 10:23 AM
RE: New Forum!!! - by Hawkeye - 07-08-2017, 11:15 PM
RE: New Forum!!! - by EdK - 06-27-2020, 05:33 PM
RE: New Forum!!! - by arvidj - 06-27-2020, 10:10 PM
RE: New Forum!!! - by EdK - 06-27-2020, 11:11 PM
RE: New Forum!!! - by Vinny - 06-28-2020, 01:34 AM
RE: New Forum!!! - by arvidj - 06-28-2020, 07:28 AM
RE: New Forum!!! - by Vinny - 06-27-2020, 08:16 PM



Users browsing this thread: 1 Guest(s)