Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe

Hello There, Guest! Register

Thread Modes

Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe

EdK

Offline

Whipping Boy

Posts: 8,739
Threads: 313
Joined: Feb 2012
Location: Arizona/Minnesota

#4

05-09-2012, 06:25 AM

Hi Dave,

I'm curious about your QCTP. What type is it? I don't think I've every seen one like that before.

Ed

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 02:17 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by EdK - 05-09-2012, 06:10 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 06:21 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by EdK - 05-09-2012, 06:25 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 09:50 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by DaveH - 05-09-2012, 07:36 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by ETC57 - 05-09-2012, 09:35 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 09:55 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by EdK - 05-09-2012, 11:51 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 11:59 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by doubleboost - 05-09-2012, 04:06 PM

Users browsing this thread: 1 Guest(s)