Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe

Hello There, Guest! Register

Thread Modes

Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe

ETC57

Offline

Junior

Posts: 576
Threads: 18
Joined: Feb 2012
Location: Washington State USA

#6

05-09-2012, 09:35 AM

Nice work Dave,

You mentioned the bore, you mean the chuck bore right? allowing you to throat larger stock.

Jerry. Popcorn

Popcorn

ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 02:17 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by EdK - 05-09-2012, 06:10 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 06:21 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by EdK - 05-09-2012, 06:25 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 09:50 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by DaveH - 05-09-2012, 07:36 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by ETC57 - 05-09-2012, 09:35 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 09:55 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by EdK - 05-09-2012, 11:51 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by Dave J - 05-09-2012, 11:59 AM

RE: Fitting a 10inch (250mm) chuck on a face plate, 12x36 lathe - by doubleboost - 05-09-2012, 04:06 PM

Users browsing this thread: 1 Guest(s)