Kondia FV-1 Head disassembly

[Mayhem]

(11-01-2014, 07:30 AM)PixMan Wrote: Any updates?

As a matter of fact, there is!  However, you will have to deal with the pics off of my phone, as I got excited and forgot to take my camera with me

OK - so the job today was drilling out the screw holes for the feed trip bracket, turning some 8mm pins to press into the holes with some LocTite (note the grove cut into each pin to stop them pressing back out) and then mark out the new holes, drill and tap to M6x1.

   
   
   
   

Once done, the selector shaft that Ken and I repaired during the week (Ken has the pics) was installed and the detent works in all three positions.  

   
   

I ran out of time to do anything else, as I had to sort out the reticulation pump for my Mum and then replace faulty sprinklers.