The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




pin vice
#1
hi all once a gane went to the boot sale and i got two more drills for 20p each and i got a pin vice for 20p so this was my next project i disassemble it as much as possible the threaded bolt is beyond reaper so a new one will be made then placed the lot in me acid bathe after a long sock all was removed and given a good scrub in ruining water then a buff up with a wire brush i had to mack up a new bolt this will have a m8 thread SOS no pics of the next bit i drilled out the wing nut two 10.5mm i then drilled and taped m8 in the end of a Peace of steel rod then turned that dawn to just under 10.5mm to fit in to the wing nut and silver soldered it in place right pics


Attached Files Thumbnail(s)
                           
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
pin vice - by krv3000 - 07-02-2012, 04:50 PM
RE: pin vice - by RobWilson - 07-02-2012, 04:55 PM
RE: pin vice - by doubleboost - 07-02-2012, 04:59 PM
RE: pin vice - by DaveH - 07-02-2012, 05:03 PM
RE: pin vice - by krv3000 - 07-02-2012, 05:39 PM
RE: pin vice - by stevec - 07-02-2012, 05:48 PM
RE: pin vice - by doubleboost - 07-02-2012, 05:55 PM
RE: pin vice - by DaveH - 07-02-2012, 06:01 PM
RE: pin vice - by EdK - 07-02-2012, 06:28 PM
RE: pin vice - by Mayhem - 07-02-2012, 07:33 PM
RE: pin vice - by krv3000 - 07-03-2012, 01:43 AM
RE: pin vice - by krv3000 - 07-04-2012, 06:41 AM
RE: pin vice - by Bill Gruby - 07-04-2012, 07:09 AM
RE: pin vice - by krv3000 - 07-05-2012, 06:22 PM
RE: pin vice - by Highpower - 07-05-2012, 09:36 PM
RE: pin vice - by krv3000 - 07-06-2012, 05:18 PM
RE: pin vice - by Rickabilly - 09-17-2012, 09:24 AM
RE: pin vice - by PixMan - 09-17-2012, 11:29 AM
RE: pin vice - by Rickabilly - 09-17-2012, 01:38 PM
RE: pin vice - by Micktoon - 09-17-2012, 12:52 PM
RE: pin vice - by DaveH - 09-17-2012, 02:41 PM
RE: pin vice - by ETC57 - 09-17-2012, 03:13 PM



Users browsing this thread: 2 Guest(s)