Drill press Tapper
#9
The handle holds the Tapper up on the shaft, raise the handle and the Tapper lowers to the work. The Tapper freewheels on the shaft in the Drill Press chuck. I use a Tapmatic power tapper most of the time. I found this unit a while back on the net so decided to give it a shot.

"Billy G" Big Grin
Reply
Thanks given by:


Messages In This Thread
Drill press Tapper - by Bill Gruby - 11-06-2012, 11:25 AM
RE: Drill press Tapper - by stevec - 11-06-2012, 03:02 PM
RE: Drill press Tapper - by Bill Gruby - 11-06-2012, 03:29 PM
RE: Drill press Tapper - by eac67gt - 03-28-2013, 08:42 AM
RE: Drill press Tapper - by sasquatch - 11-06-2012, 06:16 PM
RE: Drill press Tapper - by Mayhem - 11-07-2012, 05:53 AM
RE: Drill press Tapper - by PixMan - 11-07-2012, 06:38 AM
RE: Drill press Tapper - by stevec - 11-07-2012, 07:08 AM
RE: Drill press Tapper - by Mayhem - 11-07-2012, 07:14 AM
RE: Drill press Tapper - by Bill Gruby - 11-07-2012, 07:47 AM
RE: Drill press Tapper - by stevec - 11-07-2012, 01:54 PM
RE: Drill press Tapper - by DaveH - 11-07-2012, 09:08 AM
RE: Drill press Tapper - by Bill Gruby - 11-07-2012, 02:34 PM
RE: Drill press Tapper - by stevec - 11-07-2012, 04:30 PM
RE: Drill press Tapper - by Mayhem - 11-07-2012, 08:14 PM
RE: Drill press Tapper - by EdK - 11-08-2012, 07:31 AM
RE: Drill press Tapper - by the penguin - 11-07-2012, 09:32 PM
RE: Drill press Tapper - by Bill Gruby - 11-08-2012, 08:44 AM
RE: Drill press Tapper - by stevec - 11-08-2012, 02:30 PM
RE: Drill press Tapper - by f350ca - 11-08-2012, 03:09 PM
RE: Drill press Tapper - by f350ca - 11-08-2012, 03:37 PM
RE: Drill press Tapper - by the penguin - 11-08-2012, 07:59 PM
RE: Drill press Tapper - by krv3000 - 11-08-2012, 05:39 PM
RE: Drill press Tapper - by Bill Gruby - 11-08-2012, 06:27 PM
RE: Drill press Tapper - by stevec - 11-09-2012, 07:43 AM



Users browsing this thread: 1 Guest(s)