Carriage Stop
#11
I looked around for a piece of rod to use for the stop and spotted a broken tap. Chucked it in a drill to spin against the grinder to clean up the broken end and take the tops off the teeth. I ground the pointy end to give it a small flat - less sensitive to swarf than the 1/4" diameter rod on my other lathe.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by: stevec




Users browsing this thread: 2 Guest(s)