Spindle Crank
#1
When I'm threading a short section to a shoulder, I like to turn the spindle by hand. It's easier to use a handle at the outboard end, rather than use a chuck key or wrench to turn the chuck. I have one I made for the 9" Hercus lathe, so a big one of the same design makes sense for the Storebro lathe.

The handle locks into the spindle in the same way that bicycle handlebars join the fork tube. A long wedge of tubing jams against the main tube and the sides of the spindle.
   
   

To use, insert the tube into the end of the spindle and tighten the nut. If collets are being used with a drawbar, it can be inserted through the centre of the crank.
   

I made the handle 14" long because that is the maximum diameter I can turn over the toes of the carriage. I have to admit, it's quite a step up to have a chuck that's 10 5/8" in diameter.
   
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
#2
Nice Mike - If you twist the handles slightly you can keep cool whilst using the lathe under power Big Grin

What is the distance between the end of the spindle to the front of the chuck? It looks a decent distance in the pictures.
Hunting American dentists since 2015.
Reply
Thanks given by:
#3
With a 14" bar, it would pull the lathe across the floor. Rotfl

The chuck body is only 3" from the back plate.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
#4
Sorry Mike - I meant from the rear of the spindle (i.e. where the handle will be used). Just wondering how easy it will be to turn and still keep an eye on things.
Hunting American dentists since 2015.
Reply
Thanks given by:
#5
Yeah. It is a bit of a distance. Not quite as easy to reach as on the Hercus. It does have it's uses, though. When I had the chuck off, I used it to check the runout on the inside of the spindle. Pretty hard to turn slowly without the crank.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)