a project in filing
#1
hi all i was given this vice sum time a go so i decided to clean it up if i was at work i wood have just gone over it with the surface grinder but i had to settle with a file and its still square next thing to do is the slide and vice jaws


Attached Files Thumbnail(s)
               
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
Graemlin

You have a lot more patience than I do.

Ed
Reply
Thanks given by:
#3
no just keeping me hand in
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#4
Nice resultDroolDroolDrool
Looks more natural than a ground finish Smiley-dancenanaSmiley-dancenana
John
Reply
Thanks given by:
#5
Coming a long nicely.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#6
Graemlin More power to your elbow I say Bob , looking very square from the photos Smile

Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#7
Looking sharp as usual Bob. Smiley-eatdrink004
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#8
Graemlin Maybe we three should have a trip down to yours one night bob for a closer look Big Grin


Rob
Reply
Thanks given by:
#9
Nice work Bob.

Filing is a lost art. I occasionally break one out at work to make stuff fit (stuff made by someone else of course Big Grin) and someone is always surprised at what can be done with one.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#10
thanks all rob you no you are more than welcome to pop in and that goes for the rest of you
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)