MetalworkingFun Forum › Machining › General Metalworking Discussion v
I found Pixman a new boring bar

Thread Modes
I found Pixman a new boring bar
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
The following 3 users Like dallen's post:
oldgoaly (12-22-2014), EdK (12-22-2014), PixMan (12-22-2014)
#1
12-22-2014, 05:02 PM (This post was last modified: 12-22-2014, 05:04 PM by dallen.)
here is a photo of a boring bar that I said the next time I was in the store I would see about taking a photo of it. I had mentioned that it was 4" in dia. I was wrong its 3 inches in diameter and roughly 4 feet long.

its carbide is what I was told and from the scared up sticker on it the max load is 7000 N at 75 degrees C

   
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#2
12-22-2014, 07:25 PM
Now that's a MAN'S boring bar!
Reply
Thanks given by:
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
The following 1 user Likes dallen's post:
f350ca (12-22-2014)
#3
12-22-2014, 08:04 PM
I was going to pick it up for use on my 7X12 but figured that I'd probably just break it.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
EdK (12-23-2014)
#4
12-22-2014, 11:24 PM
(12-22-2014, 08:04 PM)dallen Wrote: I was going to pick it up for use on my 7X12 but figured that I'd probably just break it.

DA

I don't think so Dave.  That bar looks solid enough to withstand use on your 7x12 Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
Dr Stan Offline
Senior
*****
Posts: 2,324
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#5
12-28-2014, 11:26 PM
(12-22-2014, 11:24 PM)Mayhem Wrote:
(12-22-2014, 08:04 PM)dallen Wrote: I was going to pick it up for use on my 7X12 but figured that I'd probably just break it.

DA

I don't think so Dave.  That bar looks solid enough to withstand use on your 7x12 Big Grin

I think he meant that he'd break the 7X12 Big Grin
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)