Mini-Lathe Bearing Puller
#51
(06-16-2023, 04:01 PM)rleete Wrote: Mine came with that.  Doesn't seal all that well, but it keeps the vast majority out.

Yup, it's certainly much better than without it. Thumbsup

Ed
Reply
Thanks given by:
#52
Finally got the aluminum spacer done to replace the plastic spacer with. Haven't spent a lot of time in the shop lately.
It took a while to bore that out. Either I'm getting used to the gear noise or it has settled down some. After running the lathe non stop for a couple of hours the head-stock where the bearings are located was slightly warm, not even lukewarm though. I think the preload is good for now. Of course I have to undo that to install the spacer. Bash

Ed

   
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)