P&W 1830 Radial in 1/6 scale.
That's good, Bill. We can all breath again. The worst part is always the moment it takes to realize, "Yes, I do have to make a new one."
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
Thanx Hawk. Gents, it was a long haul but we have a completed crankcase.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
thats a lot of work you got there in your hand Bill, hell of a job.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
Well done Bill - that must be a relief!
Hunting American dentists since 2015.
Reply
Thanks given by:
Great piece of work Billy Smiley-signs107 Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
It has grown too large to safely handle during construction. This is the full crankcase length of 9 inches.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Very nice work Bill
John
Reply
Thanks given by:
The wife had an abdominal operation and I have been unable to get to the shop for a while.
OK, this is the humble beginnings of the custom intake manifold.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Look after the little lady Bill - we'll be here waiting patiently for future progress...
Hunting American dentists since 2015.
Reply
Thanks given by:
Will do Darren. She is getting about now so things have eased a little.

Here the brass binder is in place. When I bore the hole open for the carb I will have the binder locked in position to shape it also.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)