Big Steam Engine
#11
Nice job on the base casting. Seeing it sitting on your mill table definitely shows how big it really is. Thumbsup

Will the cylinder be aluminum or bronze?

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#12
Hi
Tom
The cylinder will be cast in bronze
I was going to use aluminium with a cast liner , but then you need a steel port face as well
Doing a propper job in bronze
John
Reply
Thanks given by:
#13
John
I was looking at your build and from what I see the cylinder is a little bit high compared to the sliding guides? I just love the size. H U G E
Nelson Collar







May the Lord Direct Your Steps
"When injustice becomes law - resistance becomes duty."
Reply
Thanks given by:
#14
Hi
Nelson
The cylinder mounting pad can be reduced in height as can the cylinder face
Once i get the cylinder cast & machined up i will get a better idea
I was looking at 1/2 inch key steel for the cross head guide
Thanks for your comments
John
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)