Todays Project - What did you do today?
I know a lot of people who could keep using that mower and not notice anything wrong.
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
I finished up the block for the test fixture for work. I need to drill a couple of holes in the arm that mates to this block and then it'll be done.

Ed

   
Reply
Thanks given by:
Looks good Ed Thumbsup
Smiley-eatdrink004
DaveH
 a child of the 60's and 50's and a bit of the 40's Smile
Reply
Thanks given by: EdK
worked on a new butt stock that I'm making for a Winchester model 1890 pump 22, the one on it is damn near split in half.

this is what I'm putting on it.
   
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
Handsome!
Reply
Thanks given by:
I picked up a 'new' drill press from a friend this summer. Bigger than my other ones, but it didn't have a quill (depth) stop. Most factory stops use a threaded rod with a nut or pair of nuts that you have to spin down to set the depth. Time consuming, so I tend not to use them. I found a posting by Gadgetbuilder that made more sense. He used a smooth rod with a pinch-type block for the adjustment. Much quicker to set.

I started with a big piece of 5/8" aluminum for the quill arm. Just needed to cut the 'arm' off one end. It takes a while to cut through a 10" wide slab of metal.
   

I set it up on my 7 1/2" rotary table and used a 2 3/8" hole saw to rough out the big hole, followed by bringing to finish size with a boring head.
   

Here we have the finished installation, including the aluminum quill arm, stop bracket, rod and stop clamp. The screw on the clamp will be recognized as an old appliance foot with a 1/4"-20 screw. If it seems too clumsy, I'll eventually replace it with a custom-made knurled screw.
   
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
Nice job Mike!
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
That sure does make more sense than a threaded rod, so many ways.

greg
Magazines have issues, everything else has problems

Reply
Thanks given by:
I like it. Much better than those dang jam nuts.
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:
Q: What is the thread size of the depth stop on a Bridgeport mill? My drill press has similar flat sided rod on it that makes it a pain to adjust the stop nuts. Because of the interrupted threads the nuts won't spin freely and there is no quick way to move them up and down the rod.

[Image: drill_press_Z_DRO_6.jpg]

I'm thinking replacing the rod with a full diameter threaded rod and using a Bridgeport "quick adjust" clamp would make things a whole lot easier?   Chin

[Image: 0023303-11.jpg]
Willie
Reply
Thanks given by:




Users browsing this thread: 64 Guest(s)