626 Mill Z Axis Feed Nut
#21
Nice project John, and good pictures. Thanks for posting.
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#22
is it dun yet
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#23
Hi
Bob
In a word "no".
The thread looked good but it is not spot on
I learned a lot and i am going to re do it.
John
Reply
Thanks given by:
#24
John, I'd be curious to know, what's not "spot on" about it?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#25
Not wishing to hijack your thread John, but did you ever post a thread about the Riser for the column? I have a Warco variant that I'd be keen to raise maybe 75 - 100mm.
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#26
(10-02-2012, 07:29 AM)Arbalest Wrote: Not wishing to hijack your thread John, but did you ever post a thread about the Riser for the column? I have a Warco variant that I'd be keen to raise maybe 75 - 100mm.

I have some pictures of the riser i will dig them out
John
Reply
Thanks given by:
#27
(10-02-2012, 07:22 AM)stevec Wrote: John, I'd be curious to know, what's not "spot on" about it?

The depth of thread should be half the pitch plus 10 thou
125 / 2 +10
This gives 72.5 thou
I machined the core register 75 thou smaller than the thread od
Instead of 75 per side
(the thread is only half depth)
John
Reply
Thanks given by:
#28
Thanks John. does that mean the root (bottom) of the thread is way narrower than the crest (top)?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#29
(10-03-2012, 07:26 AM)stevec Wrote: Thanks John. does that mean the root (bottom) of the thread is way narrower than the crest (top)?

The thread is not deep enough so the top will be to narrow in the groove
The root will be the width of the tool tip
I am going to do it again (i will try and do a bit of video)
John
Reply
Thanks given by:
#30
Are the root and the crest not supposed to be the same minus the required clearances?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)