Thanks guys. Spent a bit more time this morning playing with the setup. I thing the bit was slipping in the collet yesterday? .002"doc, 7ipm feed and 54,000rpm. The top engraving was done with a very fine endmill .5mm? The second was cut with a three sided 30 degree tool. The engraving is .135" tall on aluminium plate. I did flatten the stock on my shaper to make sure there wasn't an issue with surface irregularity.
Shawn
And yes my girlfriends last name is Steele
I'd love to see that 3 sided 30° tool.
Nice looking engraving Shawn.
Thanks guys
The grinder is advertised as 54,000 rpm but I have no real idea how fast it is. I can't tell the difference in the engraving between the lowest and highest setting so I just use the low speed to save on air.
Steve, these are similar to the bits I'm have, I ordered mine from china and they were cheap but I only plan to engrave plastic and aluminum.
Shawn