MetalworkingFun Forum

whilst helping a friend move house last week, I found this... leant up the side of a skip on the drive!!!

12mm thick, little over 8x4 in size!!!



took a few of us to move it mind!!

not sure what Im going to use it for yet... welding bench?

(04-30-2015, 12:51 PM)kingcreaky Wrote: [ -> ]not sure what Im going to use it for yet... welding bench?

That would be nice

DaveH

Stainless steel or aluminium?

Humped a couple of 2.4 meter hydraulic cylinders from my van today , they will give me  4.8 meters of 52mm Chromed rod (EN8 - EN14 ) about 1040 for you lads across the water , and two canny lengths of thick wall tube  

  



Rob 

Wow, nice haul Rob.

Ed

(05-03-2015, 11:53 AM)RobWilson. Wrote: [ -> ]Humped a couple of 2.4 meter hydraulic cylinders from my van today , ..................................  and two canny lengths of thick wall tube  

Rob 

2+2=4 I only see three.

DaveH

(05-03-2015, 12:17 PM)DaveH Wrote: [ -> ]

(05-03-2015, 11:53 AM)RobWilson. Wrote: [ -> ]Humped a couple of 2.4 meter hydraulic cylinders from my van today , ..................................  and two canny lengths of thick wall tube  

Rob 

2+2=4 I only see three.

DaveH

  Its hiding in the tube Dave ,,,,,,,,,,,,,,,,,,,,,,,,

Rob

(05-03-2015, 12:01 PM)EdK Wrote: [ -> ]Wow, nice haul Rob.  

Ed

I had to pay $20 plus shipping for a 10cm length of that tubing recently. So yeah,   Rob! 

Cheers Willie  ,,,,,,,,,,,,,,,how much !  


Rob 

(05-03-2015, 01:45 PM)RobWilson. Wrote: [ -> ]Cheers Willie  ,,,,,,,,,,,,,,,how much !  


Rob 

Approximately 10 meters worth apparently.