MetalworkingFun Forum

OK Ed, your last post about the mill was almost a week ago.     What's cooking?

must be still at the party 

(07-25-2016, 04:36 PM)Dr Stan Wrote: [ -> ]OK Ed, your last post about the mill was almost a week ago.     What's cooking?

Not quite true.

http://www.metalworkingfun.com/thread-72...l#pid56321

But, your point is well taken. Get my butt in gear!

Ed

(07-25-2016, 05:23 PM)dallen Wrote: [ -> ]must be still at the party 

Not the same party, but a party none the less. Some of my siblings and I had a great time with good food off the grill on Sunday afternoon. Some of the best shrimp I've ever tasted. That's more important than any mill will ever be. Well, almost anyway.

Ed

(07-25-2016, 06:38 PM)EdK Wrote: [ -> ]

(07-25-2016, 04:36 PM)Dr Stan Wrote: [ -> ]OK Ed, your last post about the mill was almost a week ago.     What's cooking?

Not quite true.

http://www.metalworkingfun.com/thread-72...l#pid56321

But, your point is well taken. Get my butt in gear!  

Ed

I stand corrected.  

not a damn thing wrong with some shrimp on the grill

Throw some shrimp on the barbie, mate!

For crying out loud Ed..........with all these additions to your manual mill............you shoulda' just bought a used Cnc!

Looking good by the way!

As Ken keeps inquiring,...........where's the chips?

I think you should all stop pressuring Ed to make chips. It's only been 11 months and 51 pages since the machine was delivered!
Makes me wonder what the warranty period is

(07-26-2016, 04:41 PM)wrustle Wrote: [ -> ]For crying out loud Ed...As Ken keeps inquiring,...........where's the chips?

This is why I am visiting Ken in September and not Ed - I want to make some chips myself Also, I recall owing a beer or three to a guy out in West Brookfield (or somewhere like that)...

(07-26-2016, 07:47 PM)Pete O Wrote: [ -> ]...Makes me wonder what the warranty period is

Expired is my guess Pete