MetalworkingFun Forum

Hi
Rob
Very nice finish for a roughing cut
John

(07-03-2012, 04:05 PM)RobWilson Wrote: [ -> ]

(07-03-2012, 03:49 PM)EdK Wrote: [ -> ]As usual Rob, very nice machining. That reminds me, I need to order a bull nose center for a project coming up in the near future.

Ed

Why not make some Ed I made two , interesting little project

I will make a larger one with a 3MT for the CUB lathe

Rob

Oh, now you tell me. I just ordered one from tools4cheap. I suppose I could make a larger one. That would be a nice little project. Do you have plans for one that you'd be willing to share?

Ed

I will dig the drawings out Ed ,,,,, i just used cheap/ common bearings in them as they are only used occasionally . Never had problem with them .

Build log here http://madmodder.net/index.php?topic=2479.0


Rob

(07-03-2012, 04:27 PM)RobWilson Wrote: [ -> ]I will dig the drawings out Ed ,,,,, i just used cheap/ common bearings in them as they are only used occasionally . Never had problem with them .

Build log here http://madmodder.net/index.php?topic=2479.0


Rob

Excellent Rob! Just what the doctor ordered.

Ed

Ed
I only hope you can make them as shiney as Robs
John

(07-03-2012, 05:52 PM)doubleboost Wrote: [ -> ]Ed
I only hope you can make them as shiney as Robs
John

Oh my, that's going to be a challenge but I'll try.

Ed

They can be any shape or size as long as they are shiney
John

(07-03-2012, 06:01 PM)doubleboost Wrote: [ -> ]They can be any shape or size as long as they are shiney
John

OK, that takes some of the pressure off. Now I just need to stock up on some buffing compound.

Ed

hi all its that cutting oil he is using the one with the arsenic in it that gives it shuch a good shine well dun rob

Roughing cut my ..... That screams "here's one I prepared earlier"

Just kidding Rob, excellent work as always - enjoying following this thread.