MetalworkingFun Forum › Machining › General Metalworking Discussion v
Hard turning on a knee mill.

Thread Modes
Hard turning on a knee mill.
Viperspit Offline
Freshman
**
Posts: 21
Threads: 9
Joined: Apr 2017
Location: Michigan
The following 1 user Likes Viperspit's post:
Vinny (04-23-2017)
#1
04-23-2017, 08:33 AM
Has any one out there tried hard turning in a mill? If so, what inserts do you like best and what technique do you use? Here is a YouTube video showing the inserts and technique I use. Hard Turning on a Acer Mill - YouTube

Steve
Reply
Thanks given by:
EdK Offline
Whipping Boy
*******
Posts: 8,842
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#2
04-23-2017, 01:33 PM
Nice tip Steve.

Ed
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)