| The following warnings occurred: | ||||||
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
|
|
Ball Turning, on a horizontal mill
|
|
12-20-2015, 12:47 PM
I should get points off for this, but not wanting to disturb lathe setups I used a horiz mill, lathe-like. A chuck on the spindle, a home-made arbor support being used as a steady rest, a rotary table and a vice to hold the toolbit. Just tossing out ideas for those with these mills.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Ball Turning, on a horizontal mill - by Sunset Machine - 12-20-2015, 12:47 PM
RE: Ball Turning, on a horizontal mill - by Roadracer_Al - 12-25-2015, 01:07 PM
RE: Ball Turning, on a horizontal mill - by Highpower - 12-25-2015, 02:15 PM
RE: Ball Turning, on a horizontal mill - by TomG - 12-26-2015, 08:25 AM
|
