Press brake for 20 ton hydraulic press
Off to Springs tomorrow to see if I can pick up a couple of springs Rotfl
   
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
So tomorrow you spring into action? Chin
Jerry Smiley-eatdrink004
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
"Spring On, Fall Off"
The springs are a bit long - nothing the angle grinder can't put right. Just for interest the wire is 3mm dia (.118")
   
   

Soon be 'rattle can' time Smiley-dancenana Smiley-dancenana Smiley-dancenana
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Starting to look the part Dave. So did you buy the springs or end up making them?
Hunting American dentists since 2015.
Reply
Thanks given by:
Darren, did you miss post #161
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
(07-01-2014, 09:48 AM)Mayhem Wrote: Starting to look the part Dave. So did you buy the springs or end up making them?

Darren, Steve keeps calling me a wuss, so true to form I bought them.
Winding 3mm dia spring wire isn't for wusses Rotfl Rotfl Rotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Now Dave, if you had welded the springs I'd stop calling you a WUSS.
RotflRotflRotfl

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
Bleh
Big Grin
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Nope - I saw the post in which Dave said he was going to buy them but people do change their minds...
Hunting American dentists since 2015.
Reply
Thanks given by:
Call me "mellow yellow" Smiley-dancenana
   
   
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)